Page 1 of 1

Self introduction

Posted: Fri Jun 10, 2022 10:09 am
by Antxiko
Hi everyone!

Recently I bought a Sharp MZ-80B from a flea market, I replaced the original PSU with a modern meanwell because the main transformer of the PSU was in short, so dead. I replaced the monitor board caps too and now works like a charm.

I can load BASIC from a WAV exporting it using MZFstudio and 80B specific setting. That works great (i´m using an old cassette card adaptor and the mobile phone) but I can´t get GALAXTICA working, it loads and the hangs, i´ll replace the cassete board caps too to see if it gets better.

Thanks!

Antxiko

Re: Self introduction

Posted: Tue Jun 21, 2022 12:25 pm
by mz-80a
Welcome !! Hope you get Galaxtica working.